wurker
Members-
Posts
24 -
Joined
-
Last visited
Never
Content Type
Profiles
Gallery
Everything posted by wurker
-
From the album: Suspension & Steering
Mocked up on the bench. -
From the album: Suspension & Steering
JSK rotor hat and caliper bracket, Wilwood 12.19" curved vane directional rotors and Wilwood Superlite 4 piston calipers. -
From the album: Suspension & Steering
12.19" WIlwood rotors and Wilwood Superlite calipers inside 15" wheel. -
From the album: Suspension & Steering
DAMB steering backing plate -
From the album: Suspension & Steering
Raised LCA pivots 1" -
From the album: Suspension & Steering
Raised LCA pivot points. Had to trim down the mounting bolt so it would clear the idler arm. -
From the album: Suspension & Steering
MadDat brace -
From the album: EFI/EDIS Conversion
Fuel pump final installation. -
From the album: EFI/EDIS Conversion
Fuel pressure regulator and +12v -
From the album: EFI/EDIS Conversion
getting there -
From the album: EFI/EDIS Conversion
EDIS4 module, coil pack and short plug wires. -
From the album: EFI/EDIS Conversion
Lower hose clears everything. And there's my Saturn 140a alternator with my adjuster. It's made from 1/2" square tubing with a LH & RH 5/16-24 nut on either end and heim joints. -
From the album: EFI/EDIS Conversion
Napa #8223 upper radiator hose. -
From the album: EFI/EDIS Conversion
Simple radiator mounting bracket made of 1" flat bar. -
From the album: EFI/EDIS Conversion
Stock style lower hose after trimming to fit Fiero radiator. -
From the album: EFI/EDIS Conversion
Stock style lower hose before trimming to fit Fiero radiator. -
From the album: EFI/EDIS Conversion
Distributor block off plate - made from 1/8" steel. -
From the album: EFI/EDIS Conversion
EDIS VR sensor and bracket. VR sensor is a Crown Victoria cam angle sensor. -
From the album: EFI/EDIS Conversion
Shot of EDIS 36-1 wheel pressed onto stock 2 pulley crank pulley that was turned down. There is ~.002 interference fit.